Dotmod DotAIO V2 Cartridge

Inside your DotAIO V2 by Dotmod, you can install the DotAIO V2 cartridges of the same manufacturer.

A sturdy and convenient tank, it has a 2ml capacity, an easily adjustable airflow base, and compatibility with all DotCoilV2 by Dotmod.

Special kit DotAIO V2 cartridge by Dotmod

If you are here, it is because you have a DotAIO V2 kit by Dotmod. You probably wish a spare tank to replace the old, or to alternate between different flavors. No matter the reason, the DotAIO V2 cartridge is made for your billet box!

Appreciate its nice e-liquid tank, with a sturdy tank with a capacity of 2ml; its system of adjustable airflow; or its side filling system.

The DotAIO V2 cartridge by Dotmod

The DotCoil V2 coils of the manufacturer to go with it!

Delivered empty, without any coil, your DotAIO V2 cartridge needs some to make it work correctly. You can choose the DotCoil V2 coils in Mesh SS316L of high quality.

Thanks to it, you can choose a tight vape (with the 0.7 ohm) or more aerial (with the 0.3 ohm).

To install the coil inside of your DotAIO V2 cartridge :

1. Take off the cartridge
2. Also, take off the airflow base
3. Sink the new coil with a bit of e-liquid (on the cotton)
4. Insert it inside the tank
5. Replace the airflow base, then put back the cartridge inside the pod mod
6. Then fill

The ideal draw, easy and precisely adjustable

On the low base of your cartridge, where there are the necessary connections to the DotAIO V2 pod, you'll see a little dial. The latter is meant to adjust your draw.

More precisely, by turning from right to left, you have to open or close the airflow, enabling a tight draw (reduced airflow) in MTL or more aerial (airflow wide open) in RDL.

The airflow ring of the DotAIO V2 cartridge by Dotmod

Lateral filing: up to 2ml possible!

Do you see the little strip on the side of your cartridge? By lifting it, you can easily do the filling of your 2ml tank!

Don't hesitate to lean the cartridge - or the DotAIO V2 kit - to prevent any leak of e-liquid. Do not fill the tank to the top. Finally, wait for ten minutes after the recharging, to be certain that your coil is correctly primed.

The filling of the DotAIO V2 cartridge by Dotmod

How to install the cartridge on DotAIO V2

Just like we told you, the DotAIO V2 cartridge will only operate on the DotAIO V2 of the American manufacturer Dotmod.

To install it, it will need to reach the core of the podmod. Take off the magnetic sign of your DotAIO V2, on the back. Here, you'll find the perfect place for the size of your cartridge. Insert it inside!

N.B: Don't forget to take off the 510 drip-tip before the installation of the cartridge, then put it back.

The DotAIO V2 cartridge in the DotAIO V2 kit by Dotmod

The DotAIO V2 cartridge for DotAIO V2 kit is made in USA by Dotmod.

Sold individually, without drip-tip.