Spare tanks for Gen PT60 and PT80S kit
You can't live without your PT60 or PT80S pod, but its cartridge is reaching the end of its life? Do you want a replacement cartridge so you can vape another e-liquid without having to change your coil or wait for your tank to fill up?
Vaporesso has thought of everything, here are two cartridges with a capacity of 4.5ml, compatible with the GTX coils, and identical to your original cartridge!
Identical to the original cartridge that you discovered in PT80S or PT60, this cartridge has a capacity of 4,5ml of e-liquid - enough to smoke for hours without having to worry about refilling your tank!
Made from PCTG, it is very resistant and perfectly conserves flavors contained in your e-liquids. In addition, it's extremely resistant to heat and will therefore not degrade over time!
Delivered in a set of two, they will permit you to change of e-liquid without having to wait for your tank to run out, or vape liquids with nicotine salts or CBD without having to change your coil!
The xTank cartridge for pods PT60 and PT80S by Vaporesso
Delivered without coils, these two cartridges are compatible with excellent GTX coils from Vaporesso, i.e the same that the ones delivered with pods.
To install a coil in your new tanks, you just have to make a little manipulation:
All you have to do is place your pod on its battery and you can start vaping again!
With airflow integrated into this cartridge, it will be easy to switch from a very restrictive draw to a more airy draw. Mainly made for direct inhale (MTL), this cartridge will however also allow you to do restrictive indirect inhale (RDL).
To adjust this draught, simply turn the airflow ring at the top of the cartridge to the right or left to block or open the airflow.
It's easy, precise, and useful!
For the filling of these cartridges, Vaporesso has thought of a particularly ingenious system that avoids leaks. Located at the same level as the airflow, it's enough to rotate the latter completely to the left to access the filling slot.
Blocking the air supply prevents pressure differences during filling, which in turn prevents potential leaks during use or accidental opening during the transport of your e-cig.
Once the airflow is fully rotated to the left, you will see a tab that you will have to pull to access the filling. Nothing too complicated!
The filling of the cartridge xTank for PT60/S pods by Vaporesso
The xTank cartridges PT60/80S are made by Vaporesso. They are sold in sets of two, and the coils are not included.
| Volume | 4.5ml |
|---|---|
| Compatible coils | GTX |
| Fill type | From the side |
| Drip-tip | Proprietary |
| Connector pin | Proprietary |
If you don't smoke, don't vape
Vaping is a transition to a tobacco-free life without dependency on nicotine