Dotmod Dotstick Revo Cartridge

The cartridge that will allow you to replace the old one, for a pod Dotstick Revo like new? Or the one that will invite you to alternate between different flavors of e-liquid, for a vape that follows your desires?

This is the one! The Dotstick Revo replacement cartridge is identical to the original!

Spare tank for Dotstick Revo

Exclusively dedicated to your Dotstick Revo pod, opt for this spare cartridge. A wonderful PCTG tank (plus increased robustness) and a nice capacity of 3.5ml, which will simply magnetize on the base of your pod mod!

The DotStick cartridge Revo by Dotmod

The DotCoils

In order to use the Dotstick Revo cartridge on your kit and start vaping, you will first need to install a coil. And not just any coil! One of the manufacturer's DotCoils (except the 0.15 ohm which is not compatible).

Of different values, these coils will allow a vape in indirect inhale (MTL), but also in restrictive direct inhale (RDL). They will accept all types of e-liquids (high nicotine content, nicotine salts, CBD ...).

How to install or change the coil?

1. Remove the cartridge from the Dotstick Revo pod
2. Turn it over
3. Take a new coil and soak it with a few drops of e-liquid on its cottons
4. Remove the old coil (if necessary)
5. Place the new coil
6. Re-clip the cartridge on the pod mod's magnetic base
7. Go to filling!

N.B: Generally, a coil should be changed every two to three weeks.

Adjusting the draught

It's not just the coils that will affect your throat feel. The adjustment of the air intake on the Dotstick Revo pod will also allow you to influence the draw, and therefore the desired sensation.

To do this, your electronic cigarette is equipped with a sliding knob. Turn it from right to left to adjust your airflow!

The filling of the 3.5ml tank

By equipping your podmod with its compatible Dotstick Revo cartridge, three essential things will need to be done, fit it with a coil, adjust the draw... and, of course, fill its beautiful 3.5ml PCTG tank!

On the 3.5ml Dotstick Revo cartridge, the filling is done from the side:

1. Remove the cartridge from the magnetic base of the Dotstick Revo pod
2. Pull the tab on the bottom of the cartridge
3. Tilt the cartridge slightly to avoid any leakage of e-liquid
4. Insert the tip of your bottle into the visible hole
5. Refill (never to the brim)
6. Close the tab and replace the cartridge on the magnetic base of the kit
7. Wait about ten minutes to avoid any dry hit

The filling of the Dotstick Revo cartridge by Dotmod

The Dotstick Revo cartridge for the Dotstick Revo pod is made by Dotmod. It's only available individually and comes without a coil and drip tip.