Geek Vape Obelisk 65 Cartridge

If you need to change the current tank of your Obelisk 65 pod mod or switch between two e-liquid flavors, then you need the Obelisk 65 cartridge from Geek Vape!

This replacement cartridge is identical to the original and features a 4.5ml tank, a top-fill system, a built-in airflow system, and a quality drip tip.

The cartridge that fits on Geek Vape’s Obelisk 65 pod mod!

Without its cartridge, Geek Vape’s Obelisk 65 pod mod will be useless. It is the cartridge that allows you to vape, as it houses the coil and e-liquid, as well as allows you to adjust your draw, thanks to its ingenious system of adjustable air intakes.

Because it is only made for Geek Vape’s Obelisk 65 kit, this cartridge has a specific slot for it on the Obelisk 65 pod mod.

Compatible with the B Series coils

The Obelisk 65 cartridge comes without any e-liquid or coils. It functions with the same coils the Obelisk 65 pod mod uses, that is, Geek Vape’s B Series coils.

The latter are available as packs of 5 and in several resistance values. They’re great for fans of indirect inhaling (MTL), restrictive direct inhaling (RDL), and direct inhaling (DTL)!

Every two to three weeks, you will have to replace the coil inside your cartridge:

1. Remove the cartridge from the connector of the Obelisk 65 pod mod
2. Turn it over
3. Pull the coil out of the slot
4. Grab a new coil and soak it with a few drops of e-liquid to prime it
5. Insert it in the middle of the tank, in the dedicated slot 

A built-in airflow system for ease of use!

The airflow system is clearly visible, located on top of the Obelisk 65 cartridge.

There’s a ring for adjusting the airflow, which can be rotated from right to left. Its wide air intake allows you to choose from an airy to a tight airflow!

The adjustable airflow system of Geek Vape’s Obelisk 65 cartridge

A 4.5ml tank that’s filled from above!

Because you will not spend your time removing and replacing the cartridge inside your Obelisk 65 pod mod, Geek Vape has not only provided a nice 4.5ml tank but also an ingenious top fill system.

Without removing the cartridge from the magnetic connector, you will proceed as follows:

1. Lift the silicone cap on top of the cartridge
2. Insert the tip of your bottle of e-liquid into the hole
3. Fill the tank
4. Put the silicone cap back on
5. Wait about ten minutes for the coil to soak up the e-liquid

Filling Geek Vape’s Obelisk 65 cartridge

The Obelisk 65 cartridge is manufactured by Geek Vape. It is only sold individually, without any coils.