Geek Vape U Series Cartridges (X3)

A set of 3 disposable 2ml cartridges for your Aegis U pod from Geek Vape, equipped with 1.1ohm or 0.7ohm coils.

Leave with a supply of cartridges

Stock up on U Series cartridges with this pack of three 2ml tanks.

Whether you want to replace your old cartridge or simply switch flavors throughout the day, this pack is made for you!

These cartridges clip right onto your Geek Vape Aegis U podmod, and they come with a pre-installed 1.1ohm or 0.7ohm coil.

You can fill the tank with e-liquid through a side-fill aperture.

The magnetic connector of Geek Vape’s Aegis U pod mod

A coil sealed inside the tank

No need to handle or configure anything, as the coil is already installed inside the tank. These cartridges are made from a single piece and are ready to use! Just fill the tank with your favorite e-liquid and vape.

The U Series disposable cartridges have a 1.1ohm or 0.7ohm coil, to be used between 9 and 12W. Once the coil has worn out, after about two to three weeks on average, you will have to replace the entire cartridge.

You don’t need to configure the Aegis U podmod, it automatically sets the right power for the coil it’s fitted with.

Geek Vape’s U Series cartridge and its sealed coil

A tight draw that’s ideal for beginners

With its 1.1ohm coil, the U Series cartridge is designed for a tight draw with an indirect inhale (MTL).

This type of draw is particularly suited to beginner vapers, but it is also great for nicotine salts and CBD vaping.

Note that there’s no need to adjust anything on your Aegis U podmod, it automatically sets the right power for your coil.

The air intake of Geek Vape’s Aegis U pod mod

An easy side-fill system

The advantage of a tight MTL draw is that you don’t burn through much e-liquid!

Thus, the 2ml tank of the U Series cartridge will keep you vaping for long enough.

The cartridge is easily filled from the side by doing the following:

1. Remove the cartridge from the Aegis U pod mod
2. Gently remove the silicone tab on the side of the cartridge
3. Fill your tank with e-liquid
4. Close the tab
5. Install the cartridge back onto the magnetic connector of the Aegis U pod mod
6. Wait a few minutes until the coil is primed

The side-filling hole of Geek Vape’s U Series cartridge

The U Series cartridges for the Aegis U podmod are manufactured by Geek Vape. They are only sold in packs of 3, each with a sealed 1.1ohm or 0.7ohm coil.

The manufacturer Geek Vape guarantees compatibility with its range of U podmods.