SXmini PX Pro/Pro 2 Cartridge (x2)

Get this pack of two cartridges specially made by SXmini for your PureMax and PureMax 2 podmods, each with a 2ml tank.

Disposable, the PX Pro/Pro 2 cartridge has a sealed coil, available in different values of your choice.

Warning, the two cartridges are sold without drip tip, keep those included in the box of your podmod.

SXmini's PX Pro/Pro 2 cartridge

An already-installed coil

Particularly suited to vape beginners, the PX Pro/Pro 2 cartridge has a built-in coil.

According to the type of draw wished, select at the order the value that suits you among:

• Pack of 2 PX Pro/Pro 2 cartridges with 0.4ohm sealed coil: for an airy draw in direct inhaling (only compatible with the PureMax 2)
• Pack of 2 PX Pro/Pro 2 cartridges with 0.6ohm sealed coil: for a slightly tighter vape in restrictive direct inhaling (RDL)
• Pack of 2 PX Pro/Pro 2 cartridges with 0.8ohm sealed coil: for a tight draw in indirect inhaling (MTL)
• Pack of 2 PX Pro/Pro 2 cartridges with 1.2ohm sealed coil: for a very tight vape, always in indirect inhaling (MTL). This value is suited to e-liquid with nicotine salt or CBD.

Warning, the PX Pro/Pro 2 cartridge with a 0.4ohm sealed coil is not compatible with the first version of the PureMax podmod.

After two to three weeks of use, the coil will start to show some signs of wear (loss of flavors, light burnt taste). It will be time to replace the whole cartridge with a new one.

The Liquid-Lock technology

Each PX Pro/Pro 2 cartridge has a clever system avoiding any risks of leaks: the Liquid-Lock technology.

The latter prevents the e-liquid from going on the cotton so the cartridge is leakproof, especially during the tank filling.

To activate the Liquid-Lock system, you only have to pivot the drip tip counterclockwise.

How to fill your tank?

Contrary to the first version of the PX Pro cartridge, the PX Pro/Pro 2 doesn't have a silicon strip, but a sliding trapdoor.

When the time comes to fill the 2ml tank, you only have to:

1. Take the cartridge off the podmod
2. Slide the trapdoor on the side of the cartridge to free the filling hole
3. Insert the thin tip of your bottle into the hole
4. Pour your e-liquid
5. Carefully close the trapdoor
6. Reconnect the cartridge on the podmod

Wait for some minutes before vaping it so you use a new cartridge to allow the coil to correctly prime it with e-liquid.

The filling of SXmini's PX Pro/Pro 2 cartridge

The PX Pro 2 cartridge is made by SXmini. It is exclusively sold in a pack of two and without a drip tip, available in several values of your choice.