Vaporesso iTank T Clearomizer

A top airflow on your subohm clearomizer, we tell you everything on the iTank T !

The saga of iTank clearomizers continues with the iTank T, a clearomizer meant for an airy draw in direct inhaling (DL).

With an 810 drip-tip and 6ml bulb tank, it has a top filling system.

The iTank T clearomizer presents a 24.5mm diameter and is specially made to hold the GTi coils.

Vaporesso's iTank T clearomizer on Aspire's Revolto mod

A bulb or straight look!

The iTank T clearomizer has a standard 510 connection that will allow you to associate it with any mod with a diameter of 24.5mm at least.

With a 6ml bulb tank, it will be delivered with a 3ml straight Pyrex. You can choose the one that suits you according to the desired design for your setup!

Vaporesso's iTank T with bulb tank

Made for the GTi coils

Like its big brother the iTank 2, the T version is meant for Vaporesso's GTi coils.

The manufacturer puts it in the box of your clearomizer according to the type of draw desired:

• 0.2ohm GTi MESH coils (pre-installed): to use between 60 and 70W for an airy vape
• 0.4ohm GTi MESH coils: to use between 50 and 60W for a slightly more restrictive draw

Follow our recommendation below to proceed with the change of the coil:

1. Unscrew the bottom part of the clearomizer
2. Pull on the used coil to take it off
3. Soak a new coil of some drops of e-liquid
4. Insert the latter in the same place as the old one
5. Screw the bottom part of the clearomizer
6. Fill the tank with e-liquid
7. Wait for some minutes before vaping it to let the new coil be correctly primed

A leakproof top airflow

The air intake of your iTank T is located on the top part of the clearomizer. This top airflow system greatly reduces e-liquid leaks.

You have the possibility to adjust the flow through the airflow ring: pivot the latter to free more or less the two holes.

The more you let the air come, the more airy your draw will be.

The airflow ring of Vaporesso's iTank T clearomizer

6ml in top filling

Whether you choose the 3ml straight Pyrex or the 6ml bulb Pyrex, in both cases fill your iTank by the top.

Follow the steps below to fill your clearomizer with e-liquid:

1. Push the top part of the clearomizer to free the filling hole
2. Insert the thin cap of your bottle in one of the two holes of the silicon strip
3. Pour your e-liquid up to three-quarters
4. Push the top cap back
5. Remember to wait 5 or 10 minutes before vaping if you use a new coil

The filling of Vaporesso's iTank T clearomizer

Box contents

• 1 6ml iTank T clearomizer
• 1 spare 3ml straight pyrex
• 1 0.2ohm GTi MESH coil (pre-build)
• 1 0.4ohm GTi MESH coil
• 1 bag of spare pieces

The iTank T clearomizer is made by Vaporesso.

Box contents of Vaporesso's iTank T clearomizer